What is the rotation direction of the alloy milling cutter

The alloy milling cutter realizes smooth cutting, smooth chip removal, high cutting ability, and large displacement cutting. The correct use of the rotation direction of the alloy milling cutter can improve the work production efficiency and the use time of the tool. As a manufacturer of alloy milling cutters, let's introduce it below.

The rotation direction of the milling cutter can be divided into down milling and up milling. Specifically, if the rotation direction of the milling cutter is the same as the cutting feed direction, it is down milling. At the beginning of cutting, the milling cutter can bite the workpiece and cut off the chips.

The other is reverse milling, where the rotation direction of the milling cutter is opposite to the cutting feed direction. Before starting to cut, the alloy milling cutter must slide a certain distance on the workpiece, starting from the zero cutting thickness, and gradually increasing the cutting thickness until the end of the cutting.

Because of the cutting edge of the three-face milling cutter, the cutting rotation direction is more different. There are end milling or face milling. The rotation direction of the alloy milling cutter during face milling is divided into front milling and rear milling. In forward milling, the cutting force forces the workpiece into the table, and in backward milling, the cutting force forces the workpiece to leave the table.